It gets your job of flashing files to Samsung devices done.Odin is the official Samsung firmware flash software for Windows PC. Available for both Mac and Linux systems, Heimdall is the best alternative to Odin3 Software. Heimdall: Heimdall is a cross-platform open-source tool suite used to flash firmware (aka ROMs) onto Samsung mobile devices. Odin for Linux and Mac Systems.
![]() ![]() Odin Flash Tool Software For WindowsUsually it doesn’t let me get this far, it starts to boot up and then reboots before the white booting screen clears, over and over and over again until I pull the battery out. I had gone in and done a “factory reset” and cleared the cache in the boot selection screen but I have yet to be able to physically sign in or set up the phone. It did not have, or seem to have, this or any other major issues when we bought it, as it worked fine for about a month, with the only issue being connection problems to the GPS services in the phone.This phone is currently stuck in a boot loop and the only screen that I can get it to load to and stay on without resetting again is the Downloading screen with the little green robot. We bought this phone second hand because we could not, and still can’t, afford a new phone. I turn the phone off wait 3 minutes then boot in recovery mode.Screen under icon ‘downloading… do not turn off target!!’Installed ADB and Fastboot on desktop and tried that method only to receive message ‘cannot connect to device’The end goal is to load cm13 so far no luck in even attempting it.Any assistance or direction would be appreciated.My samsung Galaxy Tab 2 7.0 (GT-P3100) is in continuous bootloop. (succeed 1 / failed 0)When finished the phone reboots as before. Phone had to have battery replaced due to swelling of the original battery (which was aftermarket) and has an official Samsung battery in it now.It has stayed on the Downloading screen the entire time I have been typing this, so I think it is safe to assume that this screen is the only way the phone doesn’t continue resetting.The downloading screen says as follows, and I have no idea if this is correct or messed up:Samsung galaxy s5 cannot seem to load TWRP using Odin here are the resultsAll threads completed. It’s a bit expensive to take to someone to repair the phone, and a new phone is out of the question, so any ideas would be appreciated. I’m assuming that this is due to the factory reset since I cannot load to set up the device.The issue, even though I’ve talked about a couple things, is that the phone will not actually go through a boot cycle. Change default save location for excel for macThe result was FAIL for 5/6 times. But when it reboots those apps are still there.I downloaded the firmwire for GT-P3100 from sammobile and tried to flash it through ODIN in different versions (3.12.3, 3.11.2, 3.10.7, 3.09). Within these 50 seconds I can uninstall some apps. It remains on for about 50/55 seconds and then reboots. In the recovery mode, the following phrase in red is written:Did not match sized ‘/system/csc/common/system/csc/default_workspace.xml’ (No data available)When I boot the tablet, I get the following message: “Unfortunately, TouchWiz.home has stopped”. I went to recovery mode and the same message in red is still there. When the tablet rebooted, the bootloop was still there. It took one and a half hour but the result was PASS. I still get the Touchwiz error, And the bootloop is still there.
0 Comments
Leave a Reply. |
AuthorJournete ArchivesCategories |